Measurement and Control Of Temperature Using RTD

Measurement and Control Of Temperature Using RTD .

We have in store a technically advanced Measurement And Control Of Temperature Using RTD. These systems are designed for measurement and control of temperature using RTD transducer. The presented systems require apparatus like heater and beaker. Beneficial for both engineering and science students, these products are in compliance with the defined parameters of the industry.

Object:

• Measurement and control of temperature using RTD transducer

Special Features :

The unit consists of following built in parts:

• ±12V DC at 100 mA, IC regulated power supply
• 6 V DC at 100 mA, IC regulated power supply
• Four op-amps ICs
• Relay 12 V DC, one change over
• One NPN transistor
• 31/2 digits display panel meter, to display temperature in ºC
• RTD sensor with 3 pin connector
• One switch for setting temperature on one side and to read actual temperature on other side
• Potentiometer to control temperature
• AC mains socket to connect load whose temperature is to be controlled
• Adequate no. of other electronic components
• Mains on/off switch and fuse 400 MA
• The unit is operative on 230V ±10% at 50Hz AC mains
• Good quality, reliable terminal/sockets are provided at appropriate places on panel for connections/ observation of waveforms
• Strongly supported by detailed operating instructions, giving details of object theory, design, procedures, report suggestions
• Weight: 4 Kg. (approx)
• Dimension: W 412 x H 150 x D 310

Other apparatus required:

• Heater 1000 W 230V
• Beaker